Fit-out underway? Book cabling before your walls close.

Get a quote 0450 513 399Get in touch
Services

Router, switch, patch panel & server rack installation in Melbourne

Cisco, Meraki, Fortinet, UniFi and MikroTik routers and switches supplied, racked, configured and documented, with patch panels and cable management done properly.

The hardware at the centre of the network

Every data point, access point, camera and phone ends up at the switch, and every device reaches the internet through the router or firewall. If those are consumer-grade, badly configured or buried under a tangle of patch leads, the whole site suffers.

Our work: Routers, switches & patch panels

See more job photos

What we install and configure

  • Cisco Catalyst, Meraki and Ubiquiti UniFi switches — managed, PoE and stackable
  • Fortinet FortiGate, Palo Alto, Cisco ASA/Firepower, Sophos XG and WatchGuard firewalls
  • MikroTik routers and RouterOS configuration — BGP, OSPF, VLAN and QoS
  • Cisco, Ubiquiti EdgeRouter and Juniper routers — WAN hand-off and ISP connectivity
  • Aruba, Netgear and TP-Link Omada switches for SMB and branch deployments
  • Dell PowerEdge, HPE ProLiant, Lenovo ThinkSystem and Cisco UCS server racking
  • Patch panels, cable management and short matched patch leads
  • Comms rack and wall cabinet installation
  • VLANs separating payments, staff, guests, cameras and phones
  • Configuration backups and a network diagram at handover

Firewalls and edge security

A proper edge firewall is the difference between a managed network and an open one. We size and configure firewalls for site complexity and budget — from a Fortinet FortiGate for a café or retail shop, through Sophos XG or WatchGuard for a multi-site business, to Palo Alto or Cisco Firepower for environments needing deep packet inspection and threat logging. VPN configuration (site-to-site and remote access) is included.

Rack tidy-ups

If your comms cupboard is a mess of unlabelled leads, we re-terminate, label and re-patch it with proper cable management, test every port, and document what goes where. It makes every future fault faster and cheaper to fix.

Questions about routers, switches & patch panels

Do you only work with Cisco?

No. We work across the full stack: Fortinet, Palo Alto, Cisco, Sophos and WatchGuard firewalls; Cisco, MikroTik, Ubiquiti and Juniper routers; Cisco, Ubiquiti, Aruba, Netgear and TP-Link switches; and Dell, HPE, Lenovo and Cisco UCS servers. We recommend based on the site's size, budget and who will manage it ongoing.

Can you configure equipment we've already bought?

Yes. We can rack, configure and test hardware you've purchased, and tell you if anything is unsuitable before it's installed.

Can you tidy our existing rack?

Yes. Rack tidy-ups are usually done after hours, with every port tested and labelled before we leave.

Related services

Areas we service

Last reviewed October 2026.

Let's get your site ready to open.

Book a free site walk. We'll review your plans and show you exactly what your fit-out needs, line by line.

Call now